blob: 2af2c50fc90b141f62bd47ccfb2e9865fc127b3a (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
|
#
# this config file will save various reports of vital system information.
# by default, all the reports are enabled and are saved in /var/backups.
#
# requires dpkg, sfdisk, and hwinfo
#
# (1) a list of all the packages installed and removed.
# this file can be used to restore the state of installed packages
# by running "dpkg --set-selections < dpkg-selections.txt
#
# (2) the partition table of all disks.
# this partition table can be used to format another disk of
# the same size. this can be handy if using software raid and
# you have a disk go bad. just replace the disk and partition it
# by running "sfdisk /dev/sdb < partitions.sdb.txt"
# (MAKE SURE YOU PARTITION THE CORRECT DISK!!!)
#
# (3) hardware information.
# detailed information on most important aspects of the hardware.
#
# here are the defaults, commented out:
# packages = yes
# packagesfile = /var/backups/dpkg-selections.txt
# partitions = yes
# NOTE: the __star__ below will be replaced by the disks found on the
# system (e.g. partitions.sda.txt, partitions.sdb.txt). If you change
# the partitionsfile default below, be sure to include the __star__
# replacement in the filename, or you will get one file for only one disk,
# the others being written to the same file, and then overwritten by the next.
# partitionsfile = /var/backups/partitions.__star__.txt
# dosfdisk = yes
# hardware = yes
# hardwarefile = /var/backups/hardware.txt
# dohwinfo = yes
|
